The short answer
ClimateEdge HVAC Service repairs gas furnaces, heat pumps, and wall heaters in Union City homes, working from our Fremont base about four miles away. We find the actual cause, explain your options, and share the cost before any work starts. Bay Area Air District rules don't require you to replace a working furnace, so a sound system can usually be repaired.
Union City homes don't need much heat for most of the year, so a furnace or heat pump can sit idle for months and then suddenly run every morning once the rainy season starts. That's usually when problems appear: a burner that won't light, a blower that pushes cold air, or a heat pump that ices up overnight. ClimateEdge HVAC Service repairs gas furnaces, heat pumps, and wall and floor heaters in homes throughout Union City (94587). We're based in Fremont, about four miles south, so reaching your home is a short drive rather than a cross-county trip.
Heating problems we fix in Union City homes
Because heating systems here sit unused through the long dry season, many winter breakdowns start with parts that have dried out, collected dust, or weakened while the system was off. A flame sensor coated in residue or a clogged filter can stop a furnace even when everything else is fine. Other problems take more work, such as a failed igniter, a worn blower motor, or a control board that has stopped responding.
We work on the heating equipment common in Union City homes, including forced-air gas furnaces in attics, garages, and closets, ducted and ductless heat pumps, and older wall and floor furnaces.
- Furnace won't start, or starts and shuts off after a few minutes
- Blower runs but the air from the vents is cool
- Burning, electrical, or strong dust smells when the heat comes on
- Banging, squealing, or rattling from the furnace or ductwork
- Heat pump covered in frost or ice, or stuck in defrost
- Thermostat that doesn't respond or misreads the room temperature
- Some rooms stay cold while others overheat
What happens during a heating repair visit
We start by asking what you've noticed: when the problem began, what the system does, and any error codes or blinking lights. Then we check the system step by step, including the thermostat signal, ignition sequence, flame, airflow, electrical parts, and venting. On gas equipment, we also check for safe combustion and proper exhaust.
Once we find the cause, we explain it in plain terms and tell you what the repair involves and what it will cost before we begin. If a part is worn but still working, we'll say so and let you decide whether to replace it now or later. We won't push a repair you don't need.
Repair or replace? What the Air District rules mean for you
Many Union City homeowners have heard that gas furnaces are being phased out and wonder whether they have to switch now. The Bay Area Air District appliance rules do not require you to replace working equipment. They apply only when an existing furnace fails or is replaced.
What changes is the equipment available later. Under the Air District's furnace rule, gas furnaces manufactured from 2029 must meet a zero-NOx emission standard, which in practice points homeowners toward heat pumps when a furnace is replaced after that date. If your furnace is in good shape, repairing it is usually the sensible choice. If it's older and needs a costly repair, we'll give you an honest view of both paths so you can plan instead of being forced into a rushed decision.
Heat pump repairs and current incentives
Heat pumps are becoming more common in Union City, and they need different care than furnaces. Low refrigerant, a faulty reversing valve, a failing defrost control, or a dirty outdoor coil can all reduce heating output. We troubleshoot both the indoor and outdoor units.
If you're thinking about replacing a furnace with a heat pump, note that the federal Energy Efficient Home Improvement Credit (25C) applied only to qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations. Bay Area homeowners can still check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change by funding cycle, so we confirm the current offer before including it in any quote.
Quick checks before you call
A few simple checks can sometimes get your heat back on, or at least help us diagnose the problem faster when we arrive.
- Confirm the thermostat is set to Heat and the setpoint is above the room temperature
- Replace thermostat batteries if the display is blank or dim
- Check the air filter and replace it if it's clogged
- Make sure the furnace power switch is on and the breaker hasn't tripped
- Check that the furnace door panel is fully closed, since many units won't run without it
Serving Union City and nearby communities
We provide heating repair throughout Union City and the rest of Alameda County near our Fremont base. We also serve Hayward, Newark, Pleasanton, Menlo Park, and East Palo Alto. If you're not sure whether your address falls within our service area, just ask when you contact us.
More services in Union City
- AC Repair in Union CityLocal service & repairs
- Heat Pump Installation in Union CityLocal service & repairs
- AC Installation in Union CityLocal service & repairs
- Furnace Repair in Union CityLocal service & repairs
