The short answer
ClimateEdge HVAC Service repairs gas furnaces and heat pumps in Newark homes, working from our base in nearby Fremont. We diagnose the problem, explain your options, and repair the system when that's the sensible choice. Bay Area Air District rules don't require you to replace a working furnace.
When your furnace or heat pump stops keeping up on a cold, damp Newark night, you want a clear answer about what's wrong and whether it's worth fixing. ClimateEdge HVAC Service is based in Fremont, about 3 miles north of Newark, and we repair heating systems in homes throughout the 94560 ZIP code. We find the actual problem, explain it in plain terms, and walk you through your options before any work starts. If a repair makes sense, we fix it. If replacement is worth discussing, we explain what current Bay Area rules mean for that choice so you can decide without pressure.
Common Heating Problems in Newark Homes
Newark winters are mild compared to much of the country, so many heating systems sit unused for months and then run hard during a few cold, wet stretches. Because of that pattern, problems that built up over the off-season often show up all at once on the first chilly night. These are the issues homeowners most often ask us to look at:
A dusty smell the first time the heat runs each fall is usually normal and fades within a short time. A smell of gas is different. If you smell gas, leave the house and contact your gas utility or 911 from outside before you contact us.
- The furnace runs but blows cool or lukewarm air
- Burners light, then shut off after a few minutes
- The igniter or pilot fails, so the system never starts
- A heat pump short cycles, stays stuck in defrost, or won't switch into heat mode
- The thermostat calls for heat but the equipment doesn't respond
- New rattling, squealing, or a burning smell when the system starts
- Weak airflow in some rooms from a failing blower motor or a clogged filter
What Happens During a Heating Repair Visit
We start by asking what you've noticed: when the problem began, whether it happens every time the heat runs, and any sounds or smells. Those details often point straight to the cause and save time.
Next, we test the system step by step. On a gas furnace, that means checking the thermostat, power and gas supply, igniter, flame sensor, safety switches, blower, and filter. On a heat pump, we also check the outdoor unit, the reversing valve, the defrost controls, and refrigerant-side performance. We look at venting and combustion safety on gas equipment, because a furnace that runs isn't automatically a furnace that runs safely.
Before we do any work, we tell you what failed, why it failed, and what the repair involves. If a part has to be ordered, we tell you how long it should take and whether the system is safe to use until then.
Repair or Replace? What Bay Area Rules Mean for You
Bay Area Air District rules do not require you to replace working equipment. They apply only when an existing furnace or water heater fails or is replaced. If your furnace can be repaired safely and reliably, keeping it running is a reasonable choice.
It still helps to know what's ahead. Under Air District Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. If your furnace is aging and needs frequent repairs, it's worth thinking now about whether your next system should be a heat pump.
If your water heater is also gas-fired, the timeline is less settled. The zero-NOx date for small water heaters under Rule 9-6 was set for 2027, but the Air District Board has been considering amendments that could delay it. Check the current rule before you plan a water heater replacement.
On cost help: the federal 25C tax credit covered qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations now. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before we include it in any quote.
Serving Newark and Nearby Cities
Newark is in Alameda County, a short drive from our Fremont base, which makes it one of the closest cities we serve. We also handle heating repair in Union City, East Palo Alto, Menlo Park, Mountain View, and Sunnyvale.
Before we arrive, it helps to note your system type if you know it, the thermostat setting, and any error codes or blinking lights on the equipment. Also check that the filter isn't badly clogged and that the furnace's power switch is on. Sometimes that's enough to get the heat back on. If it isn't, that information still shortens the diagnosis.
More services in Newark
- AC Repair in NewarkLocal service & repairs
- Heat Pump Installation in NewarkLocal service & repairs
- AC Installation in NewarkLocal service & repairs
- Furnace Repair in NewarkLocal service & repairs
