The short answer
ClimateEdge HVAC Service repairs gas furnaces, heat pumps, thermostats, and zone controls in Atherton homes. We find the cause on site and explain your options before work starts. Bay Area Air District rules don't require you to replace a working furnace, so repairing a system in good condition is often a reasonable choice.
When the heat stops working in your Atherton home, you want a clear answer about what failed and what it takes to fix it. ClimateEdge HVAC Service repairs gas furnaces, heat pumps, and the thermostats, zone controls, and ductwork that connect them for homeowners throughout Atherton (94027). We travel about 12 miles from our base in Fremont, find the problem on site, and explain your options in plain terms before any work begins.
Heating problems we often find in Atherton homes
Heating systems on this side of the Bay often sit unused through the warmer months. Then they get called on hard during cold, damp stretches of winter. That on-and-off pattern exposes parts that wore out quietly over the summer.
If your home has more than one system or a zoned setup, one area can stay cold while the rest of the house is comfortable. That usually points to a specific zone, damper, or thermostat rather than the whole system.
- Furnace starts, then shuts off after a few minutes. Common causes are a dirty flame sensor, a tripped limit switch, or restricted airflow.
- Igniter or pilot problems that keep the burners from lighting
- Blower runs, but the air coming out is cool or barely moving
- Heat pump stuck in defrost, blowing cool air in heat mode, or relying too much on backup heat
- Thermostat or zone control that doesn't call for heat when it should
- Banging, squealing, or rattling when the system starts
- A burning or musty smell that lasts past the first few minutes of the season
What happens during a heating repair visit
A technician starts by asking what you've noticed: when the problem started, whether it happens all the time or comes and goes, and which rooms are affected. Then we check the system in order. That means power and the thermostat, ignition and burners or the heat pump's outdoor unit, airflow and filters, and safety controls. On gas furnaces we also check the venting and look for signs of trouble around the heat exchanger. A repair should leave the system safe as well as working.
Once we find the cause, we explain it and walk you through your repair options before starting. Many common parts can be replaced on the same visit. If a part has to be ordered, we tell you up front and make sure the system is in a safe state while you wait.
If you smell gas, leave the house right away. Call your gas utility or 911 from outside before you call us. If a carbon monoxide alarm goes off, get everyone outside and call for emergency help.
Repair or replace? What Bay Area Air District rules mean for you
Atherton homeowners sometimes ask whether new air quality rules mean they have to give up a gas furnace. They don't. The Bay Area Air District's appliance rules do not require replacing equipment that works. The rules apply only when an existing furnace or water heater fails or is replaced.
What will change is which furnaces you can buy. Under the Air District's Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. A solid repair on a furnace in good condition can be the right call today. We'll also tell you honestly when a system is near the end of its life, so you can plan ahead instead of rushing a decision during a cold snap.
If you're also thinking about your water heater, check the current rule first. Rule 9-6 set the zero-NOx date for small water heaters at 2027. The Air District Board is considering amendments in November 2026 that could delay that date.
Heat pump repair and current incentives
More Atherton homes now heat with heat pumps, and their problems look different from a furnace's. Common causes include low refrigerant from a leak, a failing reversing valve, defrost control faults, and outdoor coils blocked by leaves or debris. A heat pump handles both heating and cooling, so a repair during heating season also protects your comfort next summer.
If a repair turns into a conversation about replacement, here is where incentives stand. The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations now. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before we include it in any quote.
Serving Atherton and nearby Peninsula communities
We handle heating repair across Atherton's 94027 ZIP code in San Mateo County. Our technicians also work in nearby Menlo Park, East Palo Alto, Redwood City, Palo Alto, and Mountain View. When you contact us, tell us what the system is doing, whether it's a furnace or a heat pump, and its approximate age if you know it. That helps us bring the right parts and get your heat back sooner.
A few quick checks before you schedule can sometimes solve the problem. Make sure the thermostat is set to heat and has fresh batteries. Confirm that the furnace power switch and circuit breaker are on. Replace the filter if it's clogged.
More services in Atherton
- AC Repair in AthertonLocal service & repairs
- Heat Pump Installation in AthertonLocal service & repairs
- AC Installation in AthertonLocal service & repairs
- Furnace Repair in AthertonLocal service & repairs
